- Based on ESP8266 Wifi IC, ESP-12F module.
- One channel RGB LED strips (can also be used for three channels LED strips)
- One extra channel white LEd strips.
- Jumper select to support WS2812 LED strips or ring board.
- Input voltage 6-27V, also power LED strip, if LED strip is 12V, input voltage should be 12V. For WS2812, input voltage should use 5V.
- Lead out all extra pins of ESP-12F for other use. Two buttons – flash and reset.
- Package Inlcudes:
- Main control board
- Plastic case kit (smaller than ESP relay board.)
- DC5.5-2.1CM power input cable
- RGB connecting cable
- normal 5050 white LED strip (10CM width) cable.
- Demo board flashed with RGB MQTT control firmware, other function not yet supported.
- More hardware documentation please see on this page.
- Demo video avaialble here.
The post ESP LED Strip Board appeared first on ElectroDragon.